Glossary

T

Taber Abraser
An instrument used to measure abrasion resistance. You may find more information about this product at www.taberindustries.com.

Tails
Finger-like spray pattern produced by improper gun or coating material adjustment.

Tape Test
A non-quantitative method of testing for adhesion whereby tape is applied to the coated surface and then removed to see if the coating comes off with it. See "Pull Test."

Tape Time
The drying time of a coating required prior to masking sections for lettering or striping after which tape will not distort the finish.

Thermocouple
A temperature measuring device.

Thermoplastic
Resins having the property of becoming soft upon the application of heat but which regain hardness after cooling.

Thermosetting
Resins having the property of becoming insoluble or hard upon the application of heat.

Thinners
A liquid (solvent) added to a coating to adjust viscosity.

Thixotropic
An adjective which describes full bodied material that undergoes a reduction in viscosity when shaken, stirred or otherwise mechanically disturbed but readily recovers its original full bodied condition upon standing.

Toluene
An aromatic solvent with a high boiling range and low flash point classified as a strong solvent.

Tooth
The profile, mechanical anchor pattern or surface roughness.

Two-Pack
A coating that is supplied in two parts and must be mixed in the correct proportions before use in order to cure.